Create Wind Flowood Manual De Instrucciones página 14

LIGHT ASSEMBLY
*Only for the model WITHOUT LIGHT
• Connect the single pin sockets on the breakout board to those on the LED panel. The LED
panel is magnetized so it attaches to the connection board by simply putting both pieces
together.
Note: While installing or removing the LED board, be careful not to touch the insulating tabs.
Do not overtighten the screws or thread them too quickly as this could cause damage to the
insulating tabs.
• Finally, place the decorative light shade by screwing it onto the LED plate.
CHECK INSTALLATION
• Check the correct operation of the ceiling fan, checking that no strange movement or mis-
alignment is observed in any part of the fan.
• If you notice any type of hum/vibration, you can proceed to adjust the blades with the bal-
ancing kit.
• This kit has self-adhesive counterweights and "u" shaped clips.
• Turn off the ceiling fan.
• You can put the clip in the center of any blade and check to see if the vibration decreases.
• Turn on the fan and check. If no change is seen, turn off the fan and add another clip on
another blade or use the adhesive weights.
In compliance with directives: 2012/19/eu and 2015/863/eu on the restriction of the use of dangerous substances in elec-
tric and electronic equipment as well as their waste disposal. The symbol with the crossed dustbin shown on the package
indicates that the product at the end of its service life shall be collected as separate waste. Therefore, any products that
have reached the end of their useful life must be given to waste disposal centres specialising in separate collection of
waste electrical and electronic equipment, or given back to the retailer at the time of purchasing new similar equipment,
on a one for one basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible negative effects on the
environment and health and optimises the recycling and reuse of components making up the apparatus. Abusive disposal
of the product by the user involves application of the administrative sanctions according to the laws.
E NGL I SH
14