3 Operation
3.3.3 Area cleaning
MODE
Press the "MODE" button
on the remote controller until
"MODE2" is displayed on the
screen.
3.3.4 Random Cleaning
MODE
Press the "MODE" button
on the remote controller until
"MODE3" is displayed on the
screen.
38 / EN
MODE2
The appliance will switch to the
mode of cleaning the 2m*2m
area that it is located.
At the end of cleaning, the ap-
pliance will switch to standby
mode.
MODE3
The appliance will switch to
random cleaning mode and will
clean the room following a ran-
dom route.
Cleaning will continue until the
appliance runs out of battery,
then it will move to the charg-
ing unit (14) to recharge.
Robot Vacuum / User's Manual