Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MP6211
Kit Installation
If your vehicle requires the use of an installation kit to mount this radio, follow the instructions
included with the installation kit to attach the radio to the mounting plate supplied with the kit.
1.
Wire and test the radio as outlined in the Universal Installation instructions.
2.
Install the radio/mounting plate assembly to the sub-dashboard according to the
instructions in the installation kit.
3.
Attach the support strap to the radio and dashboard as described in the Universal
Installation instructions.
4.
Replace the dashboard trim panel.
ISO Installation
This unit has threaded holes in the chassis side
panels which may be used with the original factory
mounting brackets of some vehicles to mount the
radio to the dashboard. Please consult with your
local car stereo shop for assistance on this type of
installation.
1.
Remove the existing factory radio from the
dashboard or center console mounting. Save all
hardware and brackets as they will be used to
mount the new radio.
2.
Carefully unsnap the plastic frame from the
front of the new radio chassis. Remove and discard the frame.
3.
Remove the factory mounting brackets and hardware from the existing radio and attach
them to the new radio. Do not exceed M5 x 9 MM maximum screw size. Longer screws
may damage components inside the chassis.
4.
Wire the new radio to the vehicle as outlined in the Universal Installation instructions.
5.
Mount the new radio assembly to the dashboard or center console using the reverse
procedure of step 1.
Remove Radio
To remove the radio after installation, remove the
trim ring by lifting in the center and pulling it off
from either side. Insert the removal keys straight
back until they lock, and then pull the radio out. If
removal keys are inserted at an angle, they will not
lock properly to release the unit.
REMOVAL KEYS
5
Publicidad
Tabla de contenido
