Tuner Operation; Preset Stations - Jensen MP6211 Manual De Instrucciones

MP6211

TUNER OPERATION

The MP6211 comes equipped with a World Tuner, allowing you to receive channels in USA,
EUROPE, LATIN, & OIRT (Russia). See "Frequency Spacing" on page 7 to learn how to
change the World Tuner options.
Select a Band
Press BAND (19) to change between three FM bands and two AM bands. Each band stores up
to six preset stations.
Tuning
Manual Tuning
Press the Up Tuning (10) or Down Tuning (11) button for more than three seconds to enter
manual tuning mode, then press the Up Tuning or Down Tuning buttons to move the radio
frequency number up or down one step.
Auto Seek Tuning
Press the Up Tuning (10) or Down Tuning (11) button for less than three seconds to move to
next station automatically.
Scan
Press SCAN (20) to scan through strong stations in the current band. The radio pauses for five
seconds at each strong station. Press SCAN again to listen to the current station.

Preset Stations

Up to six stations on each band can be stored as presets and can then be instantly recalled by
pressing the associated preset button (12-17). To store a station, turn the radio on and select
the desired band and station. Press and hold the desired preset button (numbered one through
six on the face of the radio) for more than two seconds. When stored, the preset number will
appear in the display. The station is now stored and can be re-called at any time by pressing
the corresponding preset button. Repeat for the remaining five presets on the current band and
for all presets on the other three bands.
Automatically Store / Preset Scan (AS/PS)
Automatically Store
Select six strong stations and store them in the current band using the Automatic Store feature.
To enable this feature, press and hold AS/PS (21) for more than two seconds. The radio will
automatically scan the band in use and enter strong stations into the preset memory positions
for that band. After entering the stations into memory, the unit will automatically stop at each
station for five seconds so each can be heard. When using the Automatically Store feature, the
new stations replace any stations already stored in preset memory for the selected band.
Preset Scan
Press AS/PS (21) to scan the six preset stations in the current band. The unit will stop at each
station for five seconds before continuing to the next preset station, and the preset number will
flash on the display during the preset scan. Press AS/PS again to stop scanning and listen to
the current station.
PRESS AND HOLD
Stereo
The unit will automatically pick up a stereo signal, when available. When in stereo mode, the
"ST" icon (18) appears in the display. When no stereo signal is available, the unit will
automatically revert to mono operation, and no icon will be displayed.
9
PRESET NUMBER APPEARS