Tripp-Lite AGSM500USBKJR6 Serie Manual De Operación página 3

200208108 93-2089 OmniSmart725 Owner's Manual.qxd
Quick Installation
1 Connect your UPS to
an electrical outlet.
Your UPS will run a self-test after it is
plugged in. See Basic Operation to understand
the results of its self-test.
2 Plug your computer, monitor
and external modem into
UPS/Surge outlets.
Your UPS is designed to support only
computer equipment. You will overload your
UPS if you connect high power draw
equipment such as household appliances,
laser printers or surge suppressors to its
UPS/Surge outlets.
Select models only:"Surge-only" receptacles
(identified on the back of the UPS) are used to
provide peripherals with surge protection
without committing precious battery power to
support them during blackouts.
Select UPS Operating Mode.*
3
Press the ON/OFF button to toggle your UPS
between the UPS ("
CHARGE ONLY ("
modes. Choose the operating mode based on
your location:
USA, Canada & Western Europe:
• Leave the UPS in the UPS mode at all times.
All Other Countries:
• Put the UPS in the CHARGE ONLY
mode when you are not using connected
equipment.
(WARNING! When set to "CHARGE ONLY," the UPS
will not provide battery backup during a blackout or
brownout)
• Put the UPS in the UPS mode when you
are using connected equipment.
*See Basic Operation section for a complete explanation
of each mode.
1
2
" LED lit) and the
" LED flashing)
3
3
9/12/2002 9:22 AM Page 3
NORM DELAY