Celexon CLR HomeCinema Performance UST Manual De Instrucciones página 21

STEP 4: MOUNTING WALL BRACKET
Turn the screen over and fit the four mounting brackets S6 in the slots of F1 and
F2 so that the short side of the mounting bracket faces away from the fabric.
Attach two mounting brackets at the top and bottom, centred between the
support strut and the inner frame.
S6
Draw a reference line on your wall at the height that will later be the top
edge of the screen. Both wall brackets must be positioned 30 mm below this
reference line. The distance between both wall brackets must be identical at
the top and bottom to the distance A (the centre) of both mounting brackets.
Use a spirit level to ensure straight alignment.
If possible, do not change the distance between the inner mounting brackets
of the wall brackets. This changes the stability or height adjustability of the
bracket.
Transfer the drill holes of the wall
bracket, drill the holes and attach
the two mounting rods. Use the en-
closed mounting screws and wall
plugs. (These are only suitable for
solid masonry, concrete or solid
stone. If necessary, obtain suitable
mounting material for your struc-
ture).
A
S4
Centre line of the screen
9