Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Information
Products marked with a crossed-out wheeled bin
symbol and a single black bar underneath, con-
tain parts that must be handled in compliance
with the WEEE directive/regulations. The entire
product, or the WEEE parts, can be sent to your
"Customer Center" for handling.
FCC compliance Class B
This device complies with Part 15 of the FCC Rules. Any
changes or modifications not expressly approved by the man-
ufacturer could void the user's authority to operate this de-
vice.
Operation is subject to the following two conditions:(1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
FCC Responsible party:
Name: Stuart Trott
Position: General Manager
Address: Chicago Pneumatic Tool Company
LLC 1815 Clubhouse Road Rock Hill
SC 29730
USA
Mobile: +1 800 624 4735
Email: Stuart.Trott@cp.com
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference
will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
▪ Reorient or relocate the receiving antenna.
▪ Increase the separation between the equipment and re-
ceiver.
▪ Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
▪ Consult the dealer or an experienced radio/TV techni-
cian for help.
IC compliance Class B
CAN ICES-3(B)/NMB-3(B)
(English) This device complies with Innovation, Science and
Economic Development Canada's licence-exempt RSSs. Op-
eration is subject to the following two conditions:
1) This device may not cause interference; and
2) This device must accept any interference, including inter-
ference that may cause undesired operation of the device.
(French) Le présent appareil est conforme aux CNR d'Inno-
vation, Sciences et Développement économique Canada ap-
plicables aux appareils radio exempts de licence. L'exploita-
10 / 80
tion est autorisée aux deux conditions suivantes:
1) l'appareil ne doit pas produire de brouillage;
2) l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Information Regarding Article 33 in REACH
The European Regulation (EU) No. 1907/2006 on Registra-
tion, Evaluation, Authorization and Restriction of Chemicals
(REACH) defines among other things requirements related to
communication in the supply chain. The information require-
ment applies also to products containing so called Substances
of Very High Concern (the "Candidate List"). On 27 June
2018 lead metal (CAS nr 7439-92-1) was added to the Candi-
date List.
In accordance with the above, this is to inform you that cer-
tain electrical and mechanical components in the product may
contain lead metal. This is in compliance with current sub-
stance restriction legislation and based on legit exemptions in
the RoHS Directive (2011/65/EU). Lead metal will not leak
or mutate from the product during normal use and the concen-
tration of lead metal in the complete product is well below the
applicable threshold limit. Please consider local requirements
on the disposal of lead at product end of life.
Conformity to North American standards
5008022
Regional Requirements
WARNING Regional Requirements
This product can expose you to chemicals including lead,
which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more
information go to
Safety
DO NOT DISCARD - GIVE TO USER
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this
power tool.
Failure to follow all instructions listed below may result
in electric shock, fire, and/or serious injury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
6159990230 / v.01
Listed
Conforms to UL
62368-1:2014 Ed.2
Certified to CSA
C22.2#62368-1:2014 Ed.2
https://www.p65warnings.ca.gov/
Publicidad
