Publicidad
Idiomas disponibles
Idiomas disponibles
By means of the assigning procedure up to 4 systems can be associated with the transmitter.
1. Press button "
2. Press the R. F. button of the system you wish to associate until the respective LED comes on
(see attachments "D" - "E" - "F" - "G" and refer to the relative technical manual if necessary)
The system transmits its own identification code to the transmitter (5 quick flashes of the LD LED
confirm that the assigning procedure has been successful).
The system is assigned to the first LED available. Any other systems assigned (repeating the
procedure from point 1) will be associated in sequence to the successive LEDs.
Assigning is not permitted:
more than four different systems
the same system more than once
on the same transmitter art. 5344 or art. 5354.
By means of the deletion procedure one or more systems can be removed from the transmitter memory.
1. Press button "
2. Select with the "
associated LED must be on)
3. Press button "
cancelled).
4. Press button "
has been successful)
Adding systems to/ Deleting systems from group commands
The systems assigned to the transmitters art. 5344 and art. 5354 can be controlled individually or
simultaneously if they are set to belong to the group. This affiliation or not is defined by the following
procedure.
1. Press button "
2. Select with the "
remove from the group command (the associated LED must be on). If, as well as this, the LD
LED:
Is Off – the system does not belong to the group
If you wish to add it, press the "
Is On – the system belongs to the group
If you wish to remove it, press the "
3. If necessary, select with the "
to add to or remove from the group command (the associated LED must be on).
4. Press button "
adding systems to or removing systems from the group command has been successful).
Note: if one or more systems have been set to belong to the group, in normal use when the group is
selected, the LEDs associated to these systems will come on.
Assigning a system
●
" until LED LD flashes 5 times followed by 3 quick flashes
Deleting a system
●
" until LED LD flashes 5 times followed by 3 quick flashes
►
"button (or with the "
■
" for 5 sec (2 flashes of the associated LED confirm that the system has been
●
" (5 flashed of the LD LED confirm that the procedure for deleting a system
●
" until LED LD flashes 5 times followed by 3 quick flashes
►
" button (or with the "
■
►
" button (or with the "
●
" (5 quick flashes of the LD LED confirm that the exclusion procedure of
◄
" button) the system that you wish to delete (the
◄
" button) the system that you wish to add to or
" button (the LD LED switches on)
■
" button (the LD LED switches off)
◄
" button) another system that you wish
4
Publicidad
