Publicidad
Idiomas disponibles
Idiomas disponibles
The activation commands sent by the transmitter can be inverted by means of the movement
inversion procedure.
This procedure can be useful when pressing a given button has the opposite effect on the system to
what was expected (for example when pressing the "
▼
pressing the "
"button the system moves upwards).
1. Press button "
2. Select with the "
inversion of the movement (the associated LED must be on).
3. Press buttons "
procedure has been successful)
4. Press the "
inversion procedure has been successful)
By means of the button rotation procedure the factory settings of the transmitters art. 5344 and art.
5354 can be changed from:
◄
►
"
" e "
▲
▼
"
" e "
to
▲
▼
"
" e "
◄
►
"
" e "
The first configuration is suitable for systems where the motion is vertical (roller blinds, soft shade
curtains etc.) while the second is suitable for systems whose motion is horizontal (draped curtains,
vertical, etc.).
Press simultaneously the "
that the button rotation procedure has been successful).
This procedure cancels all the settings in the transmitter memory returning it to the factory settings.
Press simultaneously the "
confirm that the reset procedure has been successful).
If intermediate stopping points are set in systems controlled by transmitters art. 5341, art. 5351,
art. 5344 and art. 5354, when a brief impulse is sent the systems activated will reach the first stopping
point in sequence.
To open or close completely the command must be held down for 4 sec.
Inverting the movement
●
" until LED LD flashes 5 times followed by 3 quick flashes.
►
" button (or with the "
▲
▼
" and "
" at the same time for 2 sec (3 flashes of LD3 confirm the
●
"button again (5 quick flashes of the LD LED confirm that the movement
Button rotation
" selection
" activation command
"selection
"activation command
●
" button and the "
●
" button and the "
Intermediate limit stops
►
"button the system moves to the left, or when
◄
" button) the system to which you wish to apply
◄
►
" - "
"buttons (6 flashes of the LD LED confirm
Reset
■
▲
▼
" - "
" - "
" buttons (2 flashes of the LD LED
5
Publicidad
