Transmitters art. 5341, art. 5351, art. 5344 and art. 5354run on a CR2430 battery. To replace the
battery on transmitters follow the directions in attachments "A" - "B".
Please note that the old battery cannot be disposed of with non-differentiated urban waste but must be
collected separately in accordance with the regulations set down by the local authorities.
Transmitters art. 5351 and 5354 can be fixed to the wall using either the double-sided tape "A" (supplied
– see attachment "C" fig. C1) or fixing bolts (not supplied – see attachment "C" fig. C2)
Art. 5341 – Art. 5351
1 flash of LED LD every 2 sec for
the entire duration of the travel
2 flashes of LED LD
1 flash of LED LD
11 flashes of LED LD
3 quick flashes of LED LD
repeated every 4 sec
Transmission frequency: 868 MHz – 915 MHz.
Two-way communication protocol M2net
Light signalling emission of radio command and status of controlled systems
Possibility of controlling up to 4 systems individually (art. 5344 – art. 5354)
Possibility of controlling up to 4 systems at the same time (art. 5341 – art. 5351 – art. 5344 – art. 5354)
Built-in R. F. antenna
Energy saving with auto shut-off after 4 seconds of inactivity
Battery: 3V type CR2430
Dimensions (mm) : 55 x 87 x 16 (art. 5341 – art. 5344) - 68 x 83 x 19 (art. 5351 – art. 5354)
Changing the battery
Wall mounting art. 5351 and art. 5354
LED signals
Art. 5344 – Art. 5354
1 flash of the LED assigned to
the system every 2 sec for the
entire duration of the travel
2 flashes of the LED assigned
to the system
1 flash of LED LD
11 flashes of the LED
assigned to the system
3 quick flashes of LED LD
repeated every 4 sec
Technical Characteristics
Correct command execution
Transmitter entered Stand-by
6
Function
System in movement
mode
System malfunction
Flat battery