AfG Berlin 74EGTT Esquema De Instalación página 16

There are risks on the machine that have not been completely eliminated from a design standpoint or with the
To provide the Customer with full information, given below are the residual risks that remain on the machine:
such actions are deemed improper and therefore strictly forbidden.
RESIDUAL RISK
Slipping or falling
Burn
Burn
Electric Shock
(Electrocution)
Electric Shock
(Electrocution)
Falling from above
Overturning of loads
Chemical
Cuts
Crushing
Ergonomics
Residual risk
installation of adequate protection devices.
HAZARDOUS SITUATION
The operator may slip due to water or dirt
on the floor.
The operator intentionally touches parts of
the equipment.
The operator intentionally touches hot
cooking substances (oil, water, steam, etc.).
Contact with live electrical parts during
maintenance operations carried out with the
electric panel powered. The operator
intervenes (with an electric tool or without
disconnecting the power) lying on the wet
floor.
Electrocution caused by malfunction of the
grounding system or electrical protection
devices.
The operator intervenes on the machine
using unsuitable systems to access the top
part (e.g. ladders or climbs on it).
Handling of the equipment or part of it
without suitable means.
The operator comes into contact with
chemicals (e.g. detergent, scale remover,
etc.)
Risk of cuts on the internal parts of the
machine frame during maintenance.
The fingers/hands of personnel can be
crushed when handling movable parts.
The operator intervenes on the appliance
without the necessary personal protective
equipment.
WARNING
When using the equipment, use individual
antislip protective devices.
When using the equipment, use individual
heat protection devices.
When using the equipment, use individual
heat protection devices.
Maintenance of the equipment must only be
carried out by qualified personnel provided
with personal protective devices against
electrocution.
Install protection devices complying with
applicable regulatory requirements
upstream of the equipment.
Do not intervene on the machine using
unsuitable systems to access the top part
(e.g. ladders or climbing on it).
Use suitable lifting systems or accessories
when handling the equipment or packaging.
Use appropriate safety measures. Always
refer to the safety data sheets and labeling
of the product used.
Use the Personal Protective Equipment
recommended in the safety data sheets.
Maintenance must only be carried out by
qualified personnel provided with personal
protective equipment (cut-resistant gloves
and garments covering the forearm).
Maintenance must only be carried out by
qualified personnel provided with personal
protective equipment (gloves).
The operator must intervene on the
equipment provided with Personal
Protective Equipment.
17