Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Before each use or daily
After each use
Every 50 hours
Yearly
Lubricating the Machine
You do not need to lubricate the machine; all the
bearings have been lubricated at the factory for the
life of the machine.
Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1.
Turn the adjustment nut counterclockwise to
loosen the cable adjustment
Figure 23
1. Electric-start switch
2. Self-propel-drive cable
3. Adjustment nut
2.
Adjust the tension on the cable
pulling it back or pushing it forward and holding
that position.
Maintenance Procedure
• Check the cutting blades.
• Clean grass clippings and dirt from under the machine.
• Service the blade-drive system.
• Service the blades.
(Figure
23).
g427094
4. Turn the nut
counterclockwise to
loosen the adjustment.
5. Turn the nut clockwise to
tighten the adjustment.
(Figure
23) by
Note:
Push the cable toward the motor to
increase the traction; pull the cable away from
the motor to decrease the traction.
3.
Turn the adjustment nut clockwise to tighten the
cable adjustment.
Note:
Tighten the nut firmly with a socket or
wrench.
Servicing the Blade-Drive
System
Service Interval: Every 50 hours
1.
Remove the blade-drive system cover
24).
1. Bolts
2.
Brush or blow out debris from the inside of the
shield and around all the parts.
21
(Figure
Figure 24
2. Cover
g426290
Publicidad
