Publicidad
Idiomas disponibles
Idiomas disponibles
Translation of the original instructions
Connection / disconnection :
• Disconnect the power supply before plugging or unplugging the
connections to/from the battery.
• Always ensure the Red clamp is connected to the «+» battery
terminal first. If it is necessary to connect the black clamp to the
vehicle chassis, make sure it is a safe distance from the battery and
the fuel line. The charger must be connected to the mains.
• After charging, disconnect the charger from the mains, then
disconnect the negative clamp from the car body and then
disconnect the positive clamp from the battery, in this order.
Connection :
• The charger must be connected to an earthed power supply.
• The connection to the power supply must be carried out in compliance
with national standards.
Maintenance :
• If the power supply cable is damaged, the replacement cable must
be obtained from the manufacturer or its service team.
• Maintenance should only be carried out by a qualified person.
• Warning ! Always disconnect from the mains before performing
maintenance on the device.
• The device does not require any specific maintenance.
• If the internal fuse is melted, it must be replaced by the manufacturer
(GYS dedicated sales service) or by an equally qualified person to
prevent any accidents.
• Do not use solvents or any agressive cleaning products.
Regulations :
• The Machine is compliant with European directives.
• The declaration of conformity is available on our website.
• EAEC Conformity marking (Eurasian Economic Community).
• Equipment in compliance with British requirements. The British Dec-
laration of Conformity is available on our website (see home page).
• Equipment in conformity with Moroccan standards.
• The declaration C( مCMIM) of conformity is available on our
website (see cover page).
Waste management:
• This product should be disposed of at an appropriate recycling
facility. Do not throw away in a household bin.
GENERAL DESCRIPTION
The GYSFLASH 30.24 HF provides a high powered stabilised power supply incorporating SMPS (Switch Mode Power Supply) technology.
Designed to sustain 6V/12V/24V battery (liquid/AGM/gel) for vehicles during diagnostic work, this device will also ensure an ideal charging
cycle for battery maintenance for the most modern vehicles and battery types. This charger can be fitted with cables up to 2x8m in 16mm².
Changing charging cables requires recalibration (see page 18). It is considered a fixed device not a mobile product.
These devices have 5 modes including 2 that are hidden:
GYSFLASH 30.24 HF
EN
13
Publicidad
