Silvercrest SSWM 900 A1 Manual De Instrucciones página 20

DANGER! Risk of burns!
During use the product gets
hot. Do not touch the product
while in use nor immediately
after use.
The temperature of accessible
surfaces may be high when the
product is operating.
m WARNING! Risk of
electric shock! Do not
immerse the product in water
or other liquids. Never hold the
product under running water.
m WARNING! Risk of
electric shock! Never use a
damaged product. Disconnect
the product from the power
supply and contact your
retailer if it is damaged.
The product is not to be used
if it has been dropped, if there
are visible signs of damage.
The product is powered only
after the on/off switch is
moved to the ON position.
Before connecting the product
to the power supply, check that
the voltage and current rating
corresponds with the power
supply details shown on the
product's rating label.
20 GB/IE
Regularly check the power
plug and the power cord for
damages. If the power cord is
damaged, it must be replaced
by the manufacturer, its service
agent or similarly qualified
persons in order to avoid a
hazard.
Protect the power cord against
damages. Do not let it hang
over sharp edges, do not
squeeze or bend it. Keep the
power cord away from hot
surfaces and open flames.
Operation
The product must not be
left unattended while it is
connected to the supply mains.
Do not move the product while
it is in operation.
Do not place the product on
hot plates (gas, electric, coal
cooking range etc.). Operate
the product on a level, stable,
clean, heat-resistant and dry
surface.
Do not cover the product while
it is in use or shortly after use,
when it is still hot.
Make sure that the power cord
is not pinched by the plates or
touches the rim of the plates.