Publicidad
Idiomas disponibles
Idiomas disponibles
1 ELECTRICAL SAFETY
INSTRUCTIONS
1
Before connecting the dispenser to the mains,
check that the voltage shown on the rating plate
matches your electricity supply. Connect the
dispenser to a single-phase supply through an
earthed socket as required by current regulations. If
the dispenser is to be disconnected from the power
supply using a single pole switch, the gap between
the contacts on this switch must be sufficiently wide
to guarantee full disconnection under category III
overload conditions.
2
Do not use extension cables to connect the
appliance.
3
To avoid any risks, if the power cable is
damaged, it must be replaced by the manufacturer,
by an authorised technician or by a similarly
qualified person.
4
The dispenser is not suitable for outdoor use.
5
The dispenser must be installed in the upright
position and always handled with care. If, even
during transport, it has been positioned horizontally,
wait 4 hours after installation before starting.
6
Before
cleaning,
dispenser by removing the plug from the socket.
7
Always
disconnect
r e m o v i ng a ny o f t h e p a n e l s f o r c l e a ni n g o r
maintenance work.
8
Do not use electrical appliances inside the food
storage compartments of the appliance, unless they
are of the type recommended by the manufacturer.
9
This appliance must not be operated by
children.
10 Do not let children play with the appliance.
11 This appliance must not be used by persons
w i t h r e d u c e d p h y s i c a l , s e n s o r y o r m e n t a l
capabilities or with a lack of experience and
knowledge unless they have supervision or have
been trained regarding the safe use of the appliance
and understand the risks involved.
12 Only persons who know and have practical
experience of the appliance are permitted access to
the inner components of the dispenser, especially
when dealing with issues regarding safety and
hygiene.
2 HYGIENIC SAFETY INSTRUCTIONS
1
This appliance is intended exclusively for
domestic and similar use.
2
For the appliance to operate correctly, room
temperature must be between +5° and +32°C.
3
Use the appliance to cool the indicated liquids
always
disconnect
the
dispenser
before
only.
4
Do not introduce dangerous or toxic liquids to
the appliance.
3 TECHNICAL CHARACTERISTICS
Transparent removable bowls
Capacity of each bowl, approx.
Dimensions:
width
depth
height
Net weight, approx.
Gross weight, approx.
Adjustable thermostats
Hermetic compressor
Air-cooled condenser
Overload protector
Noise level lower than 70 dB (A)
the
IMPORTANT
Electrical
characteristics:
featured on the data plate of each dispenser;
this data plate is situated in the lower part of
the front panel, behind the drip tray. The serial
numbers of the appliances (preceded by the
symbol #) are indicated under the appliance,
or
on
the
evaporator, found by removing the side
panels. The data specified on the data plate
are always those you should refer to.
The manufacturer reserves the right to amend the
data without notice.
4 INTRODUCTION
It is necessary to read all sections of this manual
thoroughly to familiarize yourself with all aspects of
the unit.
Like all mechanical products, this machine will
require cleaning and maintenance. Besides,
disp enser wo rking ca n be comp romised by
operator's mistakes during disassembly and
cleaning. It is strongly recommended that personnel
in change of the equipment's daily operations,
disassembly, cleaning, sanitizing and assembly, go
through these procedures in order to be properly
trained and to make sure that no misunderstandings
15
n
l
cm
cm
cm
kg
kg
n
read
surface
that
supports
1
2
3
6
6
6
19
39
60
52
52
52
60
60
60
20
38
50
22
40
52
1
2
3
the
data
the
Publicidad
