Fulgor Milano FOBQ 1000 G MBK Instrucciones Para La Instalación Y El Uso página 78

11 - Cleaning and care
EN
Care and cleaning of the appliance
To preserve its original appearance, we recommend
cleaning the cooking surfaces after each use.
ATTENTION
Make sure the barbecue is turned off and has cooled down
before executing the instructions shown below.
Cleaning of cooking parts
• Remove from the grill and from the cooking burners all
the solid materials and the excess grease using a scraper
or a metal brush with brass bristles
• Use a clean, dry cloth to make sure all surfaces are dry.
Other stainless steel surfaces
WARNING
Do not use caustic or abrasive detergents, steel wool or metal
scrapers on these stainless steel surfaces because they can
scratch and permanently damage the barbecue.
• Wash all stainless steel parts, including the thin cover,
high cover and control knobs, with a soft cloth and warm
soapy water
• Clean the surfaces, making sure to rub/dry in the direction
of the grain in order not to damage the stainless steel.
• The inside of the barbecue can be cleaned with a soft
cloth soaked in warm soapy water. The front panel/tray
placed inside can be removed for an easy cleaning.
• Use a clean, dry cloth to make sure all surfaces are dry.
Cleaning the cooking grills made of cast iron
• Clean with an adequate brass bristle brush. If necessary,
remove from barbecue, wash with warm soapy water,
rinse with water and dry carefully.
IMPORTANT
After cooking and cleaning, the cast-iron grids should be
oiled. Apply a thin layer of vegetable oil using a cloth or
brush. Afterwards, use a cloth to rub the cookware as if you
want clean the oil you just placed on it.
36
Cleaning the stainless steel grills
• Remove all solid materials and excess grease from the
grill and cooking plate using a scraper or wire brush.
• To facilitate cleaning, the two halves of the grill can be
removed with the cooking plate. For stubborn stains,
simply immerse the parts of the grill and the plate in hot
soapy water before carefully rinsing them.
• Make sure all surfaces are dried with a clean, dry cloth.
WARNING
Pay particular attention (especially when cleaning the knobs
and around them) to avoid water and soap residue from
entering the control panel containing the valves or in the
burners. Also, be careful not to touch the ignition electrode
and thermocouple. There must be 3 mm of space between the
electrode and the burners (see drawing on the next page).
3 mm