Publicidad
Idiomas disponibles
Idiomas disponibles
cardboard or plastic panels. Doing so may enable the screws to pull out from the panel due to road
vibration or sudden vehicle stops.
8.
Connect from source signal by plugging the RCA cables into the input jacks at the amplifier.
NOTE:
All "ACTIVE" inputs must have RCA jacks connected. Switch in 2CH. position,"ACTIVE" -
Front channel inputs only.Switch in 4CH. position,"ACTIVE" - All Front and Rear channel
inputs.When connecting to the 4-Channel inputs, be sure to route both front and rear RCA
cables tightly together.
CAUTION: Always ensure power is off or disconnected at the amplifier before
connecting RCA cables. Failure to do so may cause damage to the amplifier
and/or connected components.
9.
Connect the speakers. Strip the speaker wires 1/2" and insert into the speaker terminal and tighten
the set screw to secure into place. Be sure to maintain proper speaker polarity. DO NOT chassis
ground any of the speaker leads as unstable operation may result.
10. Perform a final check of the completed system wiring to ensure that all connections are accurate.
Check all power and ground connections for frayed wires and loose connections which could cause
problems. Install inline fuse near battery connection.
NOTE:
Follow the diagrams for proper signal polarity.
CAUTION: This amplifier is not recommended for impedance loads below 4-Ohm
I
NSTALLATION
7
Publicidad
