U.S.Robotics 802.11g Guia De Instalacion página 7

Client Mode installation
For online gaming using the Internet or communicating with other Ethernet-ready devices
• If you do not have security enabled on your wireless network, proceed to Client Mode
installation without security enabled.
• If you have security enabled on your wireless network, proceed to Client Mode installation
with security enabled (use Client Mode installation with security enabled if your wireless
router or access point is not broadcasting your SSID or if you have WEP enabled).
• If you are not sure whether you have security enabled on your wireless network, refer to
your router and/or access point documentation before selecting one of the two options
below.
Client Mode installation without security enabled
Attach the antenna to the back of the 5430.
•
• Plug the AC power adapter into the 12VDC jack on the back of the 5430.
• Connect one end of the included Ethernet cable to the port on the back of the 5430.
Connect the other end to the Ethernet port on your gaming console or Ethernet-ready
device.
• You're almost there. Now you need to configure your gaming console or Ethernet-ready
device. For configuration details, refer to the documentation for either your gaming console
or Ethernet-ready device.
Congratulations! Your USR5430 will automatically associate to your wireless router or access
point. You are now ready to begin gaming online through the Internet, surf the Web, or use your
Ethernet-ready device.
Client Mode installation with security enabled
• Attach the antenna to the back of the 5430.
• Plug the AC power adapter into the 12VDC jack on the back of the 5430.
• Insert a pin or paperclip to press the reset button momentarily (less than 2 seconds). The
reset button is located on the back of the 5430.
• Connect one end of the included Ethernet cable to the port on the back of the 5430. Con-
nect the other end into an Ethernet port on your computer.
• Open an Internet browser and enter http://192.168.1.201
Note: If you are not able to establish a connection to the default IP address above, you may need
to release and renew your IP address. Refer to the Ping Procedure in the Troubleshooting section
of the User Guide located on the CD-ROM for specific instructions. Alternatively, you may restart
your computer.
3