AEG BSB 14G NC-142C Manual Original página 14

SPECIFIED CONDITIONS OF USE
BS 12G, BS 14G: The Cordless drill is designed for drilling and
screwdriving for independent use away from mains supply.
BSB 12G, BSB 14G: The Cordless impact drill is designed for drilling,
percussion drilling, as well as screwdriving for independent use
away from mains supply.
Do not use this product in any other way as stated for normal use.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is in
conformity with the following standards or standardized documents.
EN 60745, EN 55014-1, EN 55014-2, in accordance with the
regulations 2006/42/EC, 2004/108/EC
Winnenden, 2010-01-19
BATTERIES
New battery packs reach full loading capacity after 4 - 5 chargings
and dischargings. Battery packs which have not been used for some
time should be recharged before use.
Temperatures in excess of 50°C (122°F) reduce the performance of
the battery pack. Avoid extended exposure to heat or sunshine (risk
of overheating).
The contacts of chargers and battery packs must be kept clean.
ADVICE FOR OPERATION
The gears can be only changed when the machine is switched off
MAINTENANCE
Use only AEG accessories and spare parts. Should components
need to be replaced which have not been described, please contact
one of our AEG service agents (see our list of guarantee/service
addresses). If needed, an exploded view of the tool can be ordered.
Please state the Article No. as well as the machine type printed
on the label and order the drawing at your local service agents or
directly at: AEG Elektrowerkzeuge, Max-Eyth-Straße 10,
D-71364 Winnenden, Germany.
SYMBOLS
Please read the instructions carefully before
starting the machine.
Accessory - Not included in standard equipment,
available as an accessory.
Remove the battery pack before starting any work on
the machine.
Do not dispose of electric tools together with household
waste material! In observance of European Directive
2002/96/EC on waste electrical and electronic
equipment and its implementation in accordance with
national law, electric tools that have reached the end of
their life must be collected separately and returned to an
environmentally compatible recycling facility.
Rainer Kumpf
Manager Product Development
Authorized to compile the technical file
GB
English
11