Create Thera Studio Manual De Instrucciones página 8

Coffee / Espresso brewing
• Heating Up: Touch any key to heat up as indicators will blink.
• Stand by mode: All indicators turn steady when heating completed, machine is ready for
operation.
• Choose the right filter for one cup, two cups or E.S.E. pods and add the right volume of
powder or a pod, tamp the powder to be at the right density or position the pod to be at
the center carefully.
• Insert the portafilter into the filter holder and rotate to make it tight enough.
• Press one cup / two cups button to brew espresso.
• The indicator will keep blinking while brewing till finished; press any key to stop at any time.
• The machine will switch to stand by mode with all indicators on after coffee brewing.
• Rotate to release the portafilter and empty the waste coffee ground, clean the filter care-
fully for next use.
How to make cappuccino, latte or hot water
• Heating Up: Touch the steam key to heat up as indicator will blink.
• When steam button is steady instead of blinking, it is heated up and ready to dispense
steam. Turn the steam dial from coffee position to steam/water position to dispense
some steam and then press the key to stop and get ready.
• Put in around 80-120 ml milk into the milk frothing pitcher to get ready to froth milk. It
is recommended to use full milk for a perfect frothing result instead of skimmed milk or
low fat milk.
• Dip the steam wand into the pitcher with around 10-15 mm, and touch the steam key to
start dispensing steam to froth milk till the cold milk is frothed double or triple in volume
and meantime the temperature is hot to be at around 60-70 °C.
• Repeat the above indications to make espresso, it's recommended to prepare in advance.
• Pour the milk foam into the espresso cup and enjoy.
• Tips: Full milk and cooled in fridge is best for milk frothing. To have perfect milk frothing,
always choose to use the right pitcher, right angle and depth during frothing. To make hot
water, you just need to double click/press the steam key and then hot water dispenses
from the steam wand; you can touch any key to stop dispensing or it stops automatically
when reaching 120 ml.
Programming the cup size
• Insert and fasten the portafilter with right filter and coffee ground. In stand by mode,
long press one or two cups button to start brewing coffee(do not release your finger till
reaching desired volume).
• The coffee machine will keep the programmed time every time you prepare a cup of coffee.
Machine cleaning
• To clean the inside parts of the system, you can choose to repeat the prescribed proce-
dures of coffee brewing several times without coffee in the filters, and try to brush the
inside of the group head with a soft brush from time to time.
• Clean the casing with a soft damp cloth.
• The water tank, drip tray and filters can be washed in warm water (not hot water).
E NGL I SH
8
CLEANING AND MAINTENANCE