Rosenbauer RTE FX Manual De Instrucciones página 22

Service and cleaning
Assembly
6.3 Assembly
6.3.1 Disassembly/assembly handle
Disassemble handle
Mounting the handle
7 Service and cleaning
22 / 245
WARNING!
Check the strength of the fastening eye before use.

When pulling up the nozzle using the fastening eye, do not enter the

danger zone below it.
The maximum pull-up height on the fastening eye is 2 storeys with

empty hose (inner diameter: 52 mm).
O-stream nozzles with disassembled bumper
► Disassemble Bumper with a screwdriver.
Drove in the handle.

Not glued.

► Release the screws with an long enough allen key.
Handle is disassembled.

► Tighten Handle on the nozzle with an allen key.
► use original fixing screws
► Drive in Bumper in the handle.
Handle is assembled.

If you cannot rectify or repair faults yourself, Rosenbauer Customer Service
or the nearest Rosenbauer service partner must be contacted immediately.
After any unauthorized repair or modification to the nozzle, it must be
checked for leaks and bursts under pressure in accordance with EN 15182.