Publicidad
Idiomas disponibles
Idiomas disponibles
Step 4:
Attach the exhaust air pipe assembly (window adapter) to the window seal plate assembly and
screw it tight.
If the window opening is smaller than the minimum length of the window slider set, cut the end without
ATTENTION
!!!
Please observe the
following instructions
for both installations:
Step 3:
Turn the exhaust air hose (exhaust air joint)
counterclockwise into the exhaust air outlet of the rear
housing.
Overall view diagram after assembly
the hatch until it fits into the window.
Never cut into the hole of the window slider set.
The exhaust air hose must be as short as possible and bent as little as
possible so that the air can flow freely.
The air conditioner should be placed on a solid floor to minimise noise and
vibration. Place the unit on a straight, level surface that is strong enough to
support the unit.
The appliance must be placed within reach of a properly earthed socket.
Never obstruct the air intake or exhaust openings of the appliance.
The exhaust air hose is precisely matched to this appliance. Do not extend it
or replace it with another hose, otherwise you could damage the appliance.
NOTE
136
Publicidad
