Note: The AC adapter must be disconnected from the DC socket at the bottom of the unit in order for the product
to operate on battery power.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the product before being charged. Rechargeable
batteries are only to be charged under adult supervision. Different types of batteries or new and used batteries are not to be mixed. Only batteries of the
same or equivalent type as recommended are to be used. Batteries are to be inserted with the correct polarity. Exhausted batteries are to be removed from
the product. The supply terminals are not to be short circuited. Do not throw batteries into a fire. Remove the batteries if you are not going to use the unit
for a long period of time. Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
WARNING: Malfunction or loss of memory may be caused by strong frequency interference or electrostatic discharge. Should any
abnormal function occur, remove the batteries and insert them again, or unplug the AC adapter from the mains socket and plug it
back in.
Warning: Disconnect the adapter if the game is not used for a long period of time to prevent overheating. When the toy is powered
by an adapter, do not play outside. Check the state of the adapter and the connection cords regularly.
If their condition is deteriorating, do not use the adapter until it has been repaired. The toy shall only be used with a transformer
for toys. The adapter is not a toy. The machine should be disconnected from the power supply to be cleaned if liquids are used for
cleaning. The toy is not intended for children under 3 years old. Misuse of transformer can cause electrical shock.
Parental advisory: transformer and adaptor for toys are not intended to be used as a toy. The usage must be under parental advice.
The toy is only to be connected with equipment bearing the following symbol
Presentation of the sewing machine
The different parts on your sewing machine are:
21
20
18
17
16
15
14
1.
Threading spindle
2.
Thread spool
3.
Bobbin holder
4.
Bobbin winder spool
5.
Hand Wheel
6.
Bobbin spindle
7.
Light button
8.
On/Off button
9.
Speed button
SW200series_IM2271_327_V08.indd 10
SW200series_IM2271_327_V08.indd 10
1
22
19
13
10. Tension adjusting screw
11. Battery compartment (under the machine)
12. Bobbin holder
13. Presser foot
14. Thread gap
15. Bobbin
16. Bobbin compartment
17. Needle
18. Needle clamp
.
or
2
3
4
5
6
7
8
9
10
11
12
10
23
24
25
19. Adjusting screw
20. Light
21. Thread cutter
22. Thread take-up lever
23. Presser foot lever
24. Foot pedal socket
25. 6V DC power socket
7/7/2021 11:20 AM
7/7/2021 11:20 AM