GRLLR Prime G4 Manual De Ensamblaje página 12

•
Mix one part washing up liquid to three parts water to make 60 to 90 ml of leak
finding solution.
•
Ensure that the control valve is closed.
•
Connect the regulator to the cylinder and the open/close valve to the burner. Ensure
that connections are correctly made and then open the gas inlet valve.
•
Spread the solution over the hose and all joins with a brush. If any bubbles appear,
then there is a leak, which must be repaired before the barbecue is used.
•
Test again, once the leak is repaired.
•
Close the gas inlet valve on the cylinder, when the test is complete.
•
If a leak is detected which cannot be repaired, do not attempt any other action but
contact your distributor for assistance.
Measures to perform before using the product for the first time
When burning off the storage grease, the appliance produce unpleasant
smoke.
This is normal, the smoke will vanish once the storage grease has been
burned out.
After the leak test, the grease used during factory storage must be burned off from the grill
before it can be used. You can burn off the storage grease by following the instructions
below:
1. Open the hood and ignite all burners according to the lighting instructions.
2. Set the burner to "MAX" and let them burn for 5 minutes with hood open.
3. Close the hood and keep the burner at "MAX" for 10 minutes
4. Close the regulator valve and turn off the burner.
5. Let the appliance cool down for 15 minutes.
6. Clean the cooking grids with grill-cleaning brush.
7. Grease the cooking grids with cooking oil.
Measures to perform before each use
To operate the grill safely and appropriately, you need to perform a few checks before each
use. Carefully go through the checklist below:
1. Check that the grill is place correctly and there are no flammable materials in the
immediate vicinity of the grill.
2. Check that the gas hose is not cracked or torn.
3. Check that the regulator is fastened tightly.
4. Check that the grill's bottom, grease tray, flame tamer and burners are clean of grease
and marinade. By doing this, you can prevent grease fires.
5. Checked that the burner holes are not covered by insert or webs.
6. Checked that there are no bristles from grill brushes stuck to the grill or grids.
Lighting Instruction
1. Open the hood.
2. Turn the regulator valve on.
3. Turn the control knobs clockwise to the "OFF" position.
4. Push down the control knob and turn it anti-clockwise to the
burner
5. When the first burner has been ignited, ignite the remaining burners as step 4.
6. Adjust the power of the flame by turning the knob to the MAX/MIN position.
7. If the burner does not light up, turn the control knob to OFF and wait 5 minutes before
attempting to ignite the burner again. If you cannot get the burner to ignite using the
piezo igniter, you can try lighting the burner up with a long match or lighter.
8. To switch the stove off, close the valve on the cylinder or the switch on the regulator if
you have finished using the stove, then turn the appliance's control knobs clockwise to
"OFF" position.
12
position, this will light the