Geutebruck G-ST 8000+G3 Manual De Instalación página 62

Turning off the device
To turn off your G-ST 8000+, proceed in the following order:
1. Close all applications and click Start in the taskbar.
2. Select Shut down and press OK.
3. Next, turn your device off completely by disconnecting the power
The 9-pin COM1 plugs are assigned by default as follows:
Figure: Pin assignment for COM1 connection – solder-side socket
Pin Function
1 JDCD
2 RxD
3 TxD
The operating system will now shut down and all data will be stored.
source.
Pin Function
4 DTR
5 Signal ground
(GND)
6 DSR
28
Back to the
table of contents
Pin Function
7 RTS
8 CTS
9 RI