Publicidad
Idiomas disponibles
Idiomas disponibles
(beyond level
) and activate the Power Booster. The
Power Booster level is indicated in the Selection / Display
area (2) with the symbol
● Cooking Zone Timer
The Cooking Zone Timer function is a countdown that can
be set, even simultaneously, on each cooking zone. At the
end of the period set, the cooking zones switch off
automatically and the user is notified with a dedicated
acoustic signal.
Activation of the cooking zone timer function
• Touch (press) the Selection/Display area (2) (power
level other than zero)
• Press
(6) relating to the cooking zone
• Use the symbols
Timer, which is shown in the Zone/Display (4); while
setting, the symbol
(6) flashes.
Note: wait 10 seconds without pressing any other
command, so that the Cooking Zone Timer will start.
Note: by pressing and holding
zone Timer is reset.
If desired, repeat the operation for several cooking
zones:
Each cooking zone can have a different Timer set; in the
display (4) the countdown of the cooking zone selected at
that moment will appear; if no zone is selected, press the
Display (4) to view the STAND-ALONE Timer countdown.
When the timer has finished the countdown, an acoustic
signal sounds and the cooking zone switches off.
To switch off the Timer:
• select the cooking zone (2)
• set the duration of the Timer to
(5).
The countdown display mode is the same as for the
STAND-ALONE Timer.
(see STAND-ALONE Timer paragraph in the WEB version
of this manual).
● Bridge Zones
Thanks to the Bridge function, the cooking zones can
operate in a combined way, creating a single zone with the
same power level. This function allows evenly distributed
cooking with large-sized pots and pans.
It is possible to use the front cooking zone in combination
with the corresponding rear one (to check which zones
feature this function, see the illustrated part of this manual).
To activate the Bridge Function:
• simultaneously select both cooking zones you wish
to use
• the Display (2) of the "rear" cooking zone will show the
.
(5) to set the duration of the
(6) again, the cooking
, using
symbol
• using the Selection bar (3), it will be possible to set the
operating Level (Power), which will be shown on the
Display (2) of the "front" zone
To disable the Bridge Function, simply repeat the activation
procedure
Note: the Cooking Zone Timer, activated during the Bridge
Function, causes the automatic shut-down of both cooking
zones, as in this case they are considered a single
combined area.
● Power Limitation
The Power Limitation function allows the product to be
used while limiting its maximum absorption, adjusting the
absorbed power in all active cooking zones, ensuring that
the total absorbed power of the hob does not exceed the
set maximum absorption level.
Note: the setting must be made with the hob switched off,
without pressing the
is connected to the mains, or reconnected to the mains,
within the next 2 minutes.
To set the Power Limitation:
• press
(which will flash, only for the first 2 minutes
after the product has been switched on)
• while keeping it held down, press, one at a time, all the
Selection/Display areas (2) of the cooking zones, in this
sequence, (CF-2 -> CR-2) as shown in the figure:
At this point, the Display (CF-2) will show the symbols
and
alternately and the Display (CR-2) will show the
symbol
• select the Display (CF-2), the Selection bar (3) will light
up; select the penultimate vertical line on this bar. Now, the
Display (CF-2) will show the symbols
alternately.
At this point, it will be possible to change the absorption
value of the hob: select the Display (CR-2) and the
14
ON/OFF (1) button, when the hob
and
Publicidad
