Publicidad
Idiomas disponibles
Idiomas disponibles
8. LCD Display
8.3 General Operation
· Switching the E-bike System Mode ON/OFF
To switch on the E-bike system and provide the power supply to the controller, hold
the On/Off button for 1s. To switch off E-bike system, hold the On/Off button for 1s.
The E-bike system no longer uses the battery power.
When E-bike system is switched off , the leakage current is less than 1 μA.
When the E-bike is parked for over 15 minutes, the E-bike system switches off
automatically.
· Display interface
After switching on the E-bike system, the display shows Current Speed and ODO(total
distance) by default. Press the ON/OFF button to switch between indication functions
below: ODO (Km)→ Trip (Km) → Motor Power (W)→ODO (Km)→ Max. Speed (Km/h)→ Avg.
Speed (Km/h) , it cycles back to ODO km again.
Display indication cycle interface
· Push-assistance
To activate the push-assistance function, press and hold the DOWN button. After
1 seconds, E-bike is activated to go at a uniform speed of 6 Km/h while the screen
1 seconds, E-bike is activated to go at a uniform speed of 6 Km/h while the screen
displays "
& P ". The push-assistance function will be switched off as soon as
you release the DOWN button and ebike gets back to the status before the push
assistance is engaged.
Push-assist display interface
The power-assisted push function can only be used when the user pushes the electric
vehicle, please do not use it in the riding state
21
ENGLISH
Publicidad
