Publicidad
Technical specifications
Power Requirements
General Power Tools Safety Warnings
Safety Warnings for Inverter Welders
Parts
Installation (SMAW)
Installation (TIG)
Start Up
Maintenance
Symbology
Troubleshooting
Authorized Service Centers
Warranty Policy
Use and care recommendations
When the machine overheats, the thermal protector will activate, turning the
welder off and turning the LED light ALARM on.
Let the welder cool for 15 minutes and turn it back on.
It is recommended to use a 12 AWG extension cord and connect it to an INDEPENDENT
CHARGING CENTER.
Perform periodic MAINTENANCE to your machine (page 11).
2
ENGLISH
Contents
3
3
To gain the best performance of
the tool, prolong the duty life,
4
make the Warranty valid if
necessary, and to avoid hazards
5
of fatal injuries please read and
understand this Manual before
6
7
Keep this manual for future references.
8
The illustrations in this manual are for reference
9
only. They might be different from the real tool.
11
11
12
13
14
SOIN-130/200
CAUTION
using the tool.
Publicidad
