Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Each grill burner is tested and calibrated at the factory prior to shipment; however, variations in the local gas supply
may make it necessary to adjust the burners. Please visually check the flames of the burners. Always visually
inspect your grill before lighting. Replace any hose that is frayed or cracked. Look for anything that could block
ventilation and remove such a blockage or move the grill. After lighting, check the flame pattern to ensure you
have even heat distribution for each burner. If burners don't light up, or if the flame pattern is uneven, see the
Troubleshooting section.
1. Read the instructions before lighting.
2. If the burner does not ignite in 5 seconds, turn the burner control knob(s) off, wait 5 minutes and repeat
the lighting procedure.
3. Inspect the gas supply hose prior to turning the gas "ON". If there is evidence of cuts, wear, or abrasion,
it must be replaced prior to use. Do not use the grill if the odor of gas is present. Only use the pressure
regulator and hose assembly supplied with the unit.
4. Never use regulators and hose assemblies other than those supplied with the grill. If a replacement is
necessary, contact the manufacturer to get the proper replacement. The replacement must be as per the
specifications in the Owner's Manual. DO NOT LEAVE THE GRILL UNATTENDED WHILE COOKING.
LIGHTING THE BURNERS USING ELECTRONIC IGNITION
1. Turn ALL control knobs to "OFF" position.
2. Turn gas supply on at LP cylinder valve or at regulator.
3. Push in control knob and turn it anti-clockwise to "HI" position. Push and hold
ignitor button to light the burner.
4. If the burner does not ignite, turn control knob to "OFF" position, wait for 5
minutes before attempting to relight the burner.
5. If the burner ignites, repeat for other burners, and turn the control knobs to
the temperature setting required for your food.
* Should the burners still fail to ignite, check the gas supply.
MANUALLY LIGHTING THE BURNERS WITH MATCH STICK
1. Turn ALL control knobs to "OFF" position.
2. Turn gas supply on at LP cylinder valve or at regulator.
3. Put a match in the match holder. Match holder is attached to side panel.
4. Place the lit match through the match lighting hole on side panel. Make sure the lit match is close to the burner
ports.
5. Push in control knob and turn it anti-clockwise to "HI" position. The burner should light immediately.
6. If the burner does not ignite, turn control knob to "OFF" position, wait for 5 minutes before attempting to relight
the burner.
7. If the burner ignites, repeat for other burners, and turn control knobs to the temperature setting required for
your food.
* Should the burners still fail to ignite, check the gas supply.
TURNING OFF YOUR GRILL
1. Turn off the gas supply at the LP cylinder by turning the valve clockwise to a full stop.
2. Turn all burner control knobs to "OFF" position.
!
WARNING:
BEFORE LIGHTING
7
!
Ignitor
Publicidad
