Toshiba RAS-B10GKVP-E Manual Del Propietário página 27

Toshiba Daiseikai ilmalämpöpumppujen myynti, huolto ja asennus: Jäähdytinpalvelu RefGroup Oy.
Cleaning the air ionizer
• Clean the air ionizer when you clean the plasma pure filter. (Clean approximately once
every six months.)
Preparation:
1. Turn off the power supply.
WARNING
Touching the ends of the metal pins inside the air ionizer (dark blue) can result in an
electrical shock.
1
Fully open the vertical air flow louvers by hand.
2
Remove the dust on the air ionizer.
• Use a toothbrush to rub the ends of the metal pins inside the air ionizer (dark blue)
three or four times.
• Do not use cotton swabs or other objects with fluff.
3
Close the vertical air flow louvers.
Cleaning the plasma pure filter
• Clean the plasma pure filter when the FILTER indicator (orange) turns on.
(This indicator turns on after PURE operation of about 1000 hours.)
• After cleaning is finished, push the RESET button on the indoor unit.
• Perform cleaning about once every six months.
• Even if the FILTER indicator does not turn on, clean the plasma pure filter whenever the
unit makes a humming, clicking, or buzzing sound. If the indicator turns on during the
night, the air conditioner can still be used until the morning without a problem, but be sure
to perform cleaning as soon as possible.
Preparation:
1. Turn off the power supply.
1
Open the air inlet grille.
Lift up the air inlet grille until it clicks into place.
2
Grasp the left and right handles of the air filter and lift up slightly and then pull
downward to remove the filter from the filter holder.
3
Take out the plasma pure filter.
• Grasp the handles, and then pull out as shown in a and b.
Checks after cleaning the plasma pure filter
1. Confirm the FILTER indicator does not turn on by activating PURE operation for one
hour or more.
<If it does not turn on, it is normal>
2. If the FILTER indicator turns on, recheck the following.
a) Fitting of the plasma pure filter
b) Fitting of the air inlet grille
And, reconfirm the FILTER indicator does not turn on by activating PURE operation for
another one hour or more.
<If it does not turn on, it is normal>
3. In case the FILTER indicator does turn on, please call a service representative.
21
www.ilmalämpöpumput.com
1
2
EN