Publicidad
Idiomas disponibles
Idiomas disponibles
Remove the standard nozzle by turning the nozzle
2.
counterclockwise using the wrench.
1
Fig.40
► 1. Wrench 2. Standard nozzle
Remove the O-ring from the standard nozzle, and
3.
then attach it to the ULV nozzle.
1
Fig.41
► 1. O-ring 2. Standard nozzle 3. ULV nozzle
Attach the ULV nozzle by turning the nozzle clock-
4.
wise using the wrench.
Fig.42
► 1. Wrench 2. ULV nozzle
5.
2
2
Fig.43
► 1. Screw 2. End nozzle
3
2
1
19 ENGLISH
NOTICE:
Do not tighten the nozzle too much.
The recommended tightening torque is approxi-
mately 1.0 N•m. Tightening the nozzle too much may
damage the mounting part for nozzle.
Attach the end nozzle, and then tighten the screw.
1
2
Publicidad
