Blades Bearing The Symbol - Dolmar RM-72.13 H Manual De Instrucciones

1
– 10 A fuse = protects the main and power circuits of the electronic
board. When it blows, the machine stops and the dashboard light
switches off.
– 25 A fuse = protects the battery charger circuit. When it blows,
the battery gradually runs out and the machine will have problems
starting.
The fuse capacity is indicated on the fuse.
With Honda engine
– 10 A fuse = protects the main and power circuits of the elec-
tronic board. When it blows, the machine stops and the dash-
board light switches off.
– 25 A fuse = protects the battery charger circuit. When it
blows, the battery gradually runs out and the machine will
have problems starting.
– T-6.3 A fuse (delayed) (2)
= protects the main and
power circuits of the elec-
tronic board. When it
blows, the machine stops
and the dashboard light
switches off.
1
2
IMPORTANT
A blown fuse must always be replaced by
one of the same type and ampere rating, and never with one of
another rating.
If problems persist, contact Your Dealer.
6.3.5 Replacing bulb (if fitted)
The bulb (18W) has a bayonet fitting and is installed in the bulb
holder (1) which can be taken out by turning it anti-clockwise with pli-
ers.
1
6.3.6 Dismantling, replacing and remounting the blade
Always wear work gloves when han-
dling the blade.
Damaged or bent blade must always be
replaced; never try to repair it! ALWAYS USE ORIGINAL

BLADES BEARING THE SYMBOL

Only blades with the following codes must be used on this machine:
84109503/0 or 84109502/0
1
!
EN 25