Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting Tips ...
Problem
Surface burners do not light, do not
light fully, or do not stay lit.
Flames are completely or mostly yellow
or orange.
when light button is pressed.
Oven light does not turn on when light
button is pressed.
22
Possible Cause/Solution
Ensure any gas supply valves and propane tank valve are opened. If
air is in the supply line, it may take up to a minute for the air to purge
and the burner to light.
the clicking of the ignition system when the knob is pressed. Continue
pressing for at least 5 seconds until the flame sensor is heated
Gas pressure is either too low or too high.
and Cleaning section.
Moisture is present on the burner. With burner off and cool, dry burner
thoroughly.
Ensure gas supply valves and propane tank valve are opened. If air is
in the supply line, it may take up to a minute for the air to purge and
the burner to light.
for the oven pilot to light and for the pilot sensor to become heated. If
air is in the gas line, this process may take over a minute.
Gas pressure is either too low or too high.
signs of flickering orange due to dust particles in the gas or air.
Gas pressure is too low.
Cleaning section.
Installation Instructions.
LED board or switch needs to be replaced. Contact GE Appliances for
service.
the Installation Instructions.
Cleaning section.
49-2001566 Rev. 0
Publicidad
