Publicidad
Idiomas disponibles
Idiomas disponibles
Wheel Bearing Tool Set | for Mercedes-Benz
COMPONENTS
A1
Spindle, required for assembly and disassembly
A2
Spindle nut, required for disassembly and assembly
B
Pressure bell, required for assembly and disassembly
C
Pressure piece, required for removal of the bearing
D
Pressure bell, required for counter holding while assembly of bearing
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This tool set is required for assembly and disassembly of wheel ball bearings on Mercedes Benz
Types W124, 129, 201 and 202.
SAFETY INFORMATIONS
● Keep children and other persons away from the working area.
● Do not allow children to play with this tool or its packaging.
● Do not use the tool if parts are missing or damaged.
● Use the tool for the intended purpose only.
● Never place the tool on the vehicle battery. There is a risk of a short circuit.
● Caution: At the moment when parts to be pulled off are loosened, it can happen that the pull-
off device with the loosened component part spring back and thus represent a danger.
Therefor the user should never be positioned behind the wheel puller in the loosening
direction.
● Always wear personal protective equipment prescribed in accordance with the accident
prevention specifications.
● Before every operational use of the wheel bearing tool, a visual check must be carried out to
determine any damages and to replace any damaged parts if required.
● Every part which is suspected of being overloaded must be taken out of operation immediately
and replaced.
● Ensure before the loading of individual screw threads that sufficient turns of the thread have
been made.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 64100
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
