Roborock Flexi Lite Manual Del Usuario página 7

Notes:
• The product is equipped with a built-in high-
performance lithium-ion rechargeable battery pack.
To maintain battery performance, keep the product
charged for normal use.
• Self-cleaning can only be used when the vacuum
cleaner is charging and the battery level is ≥10%. Do
not lift the vacuum cleaner during the self-cleaning
process.
• Always place the vacuum cleaner on the charging
dock after use to prevent water stains.
Drying
C9
Drying starts automatically after self-
cleaning is completed. To manually start
or stop drying, press the button on the
docked vacuum cleaner.
Routine Maintenance
D
To maintain optimal performance of the
product, refer to the following table for
routine maintenance.
Maintenance
Parts
Frequency
Roller 2–4 weeks
Filter 1 month
Cleaning head
and dirty water 1 month
pipe
Dirty tank 1 month
Charging dock As needed
Parts
Charging
contacts
Roller cover
Note: The frequency of replacement may vary with the
actual situation. If abnormal wear occurs, replace the
parts immediately.
Product Maintenance
If this product is left unused for a
prolonged period of time, fully charge it and
unplug it before storing it in a cool and dry
place. Do not place the product in humid
locations or under direct sunlight. Charge
it at least once every 3 months to avoid
overdischarge.
Cleaning the Vacuum Cleaner
Wipe and clean the vacuum cleaner with a
soft and dry cloth. Before cleaning, remove
Replacement
the vacuum cleaner from the charging dock
Frequency
and switch it off.
6–12 months
Cleaning the Dirty Tank and
D1
6–12 months
Filter
D1–1—Take out the dirty tank, pull out the
N/A
cover, and take out the filter from the
cover. Remove any trash attached
N/A
to the filter using the provided
maintenance brush. If the filter is
N/A
dirty, rinse it with cold water and
Maintenance Replacement
Frequency Frequency
1 month N/A
2–4 weeks N/A
06
then shake off the residual water.
D1–2—Dry all parts thoroughly before
installing them back in place.
Notes:
• Use a second filter if necessary.
• Do not touch the filter with your hands, brushes, or
sharp objects to avoid damage to the filter.
Cleaning the Roller and
D2
Roller Cover
D2–1— Press the release buttons on both
sides of the cover simultaneously and
lift the cover upwards to detach it.
D2–2— Press the buttons on one side of the
roller and pull the roller out from
the side. Remove any dirt attached
to the roller using the provided
maintenance brush, and rinse it with
clean water.
Notes:
• Use the maintenance brush carefully to avoid injury.
• Before you clean the roller, make sure that the
vacuum cleaner is switched off or in upright and
locked position
D2–3— Rinse the detached roller cover with
clean water.
D2–4— Reinstall the roller and roller cover in
the correct order.