Publicidad
Idiomas disponibles
Idiomas disponibles
is empty during use, the vacuum cleaner
will provide audio and visual alerts. Add
water into the clean tank or empty the dirty
tank before continuing.
Emptying the Dirty Tank
C7
C7–1— Hold the body of the dirty tank
with one hand, push the dirty tank
release with another hand, and then
remove the tank.
C7–2— Gently lift out the handle of the
cover to remove it, and then pour
out the dirty water.
C7–3— Reinstall the cover, tilt the dirty tank,
install the bottom in place, and then
gently push the tank inward until it
clicks in place.
Charging and Self-Cleaning
C8
1. Lock the cleaning head, and place the
vacuum cleaner onto the charging dock.
The voice alert "Start Charging" indicates
that the vacuum cleaner is charging.
2. Press the
button on the top of the
handle to start self-cleaning using hot
water. Press and hold the
seconds to switch to DEEP self-cleaning
mode using hot water. Alternatively, set
the self-cleaning type to self-cleaning
using water at room temperature or self-
cleaning using warm water in the app.
3. After self-cleaning finishes, empty the
dirty tank to prevent odors.
Notes:
• The product is equipped with a built-in high-
performance lithium-ion rechargeable battery pack.
To maintain battery performance, keep the product
charged for normal use.
• Self-cleaning can only be used when the vacuum
cleaner is charging and the battery level is ≥20%. Do
not lift the vacuum cleaner during the self-cleaning
process.
• Always place the vacuum cleaner on the charging
dock after use to prevent water stains.
Drying
C9
Drying starts automatically after self-
cleaning is completed. To manually start
or stop drying, press the
docked vacuum cleaner.
Note:
You can use the Roborock app to stop the
automatic drying that initiates after the self-cleaning
process.
Voice Alert Settings
Connect to the app to adjust the volume of
voice alerts.
Routine Maintenance
D
To maintain optimal performance of the
product, refer to the following table for
button for 2
routine maintenance.
Parts
Roller
Filter
button on the
Maintenance
Replacement
Frequency
Frequency
2–4 weeks
6–12 months
1 month
6–12 months
06
Maintenance
Parts
Frequency
Cleaning head
and dirty water
1 month
pipe
Dirty tank
1 month
Charging dock
As needed
Charging
1 month
contacts
Roller cover
2–4 weeks
Smart active
As needed
drive wheels
Note:
The frequency of replacement may vary with the
actual situation. If abnormal wear occurs, replace the
parts immediately.
Product Maintenance
If this product is left unused for a
prolonged period of time, fully charge it and
unplug it before storing it in a cool and dry
place. Do not place the product in humid
locations or under direct sunlight. Charge
it at least once every 3 months to avoid
overdischarge.
Cleaning the Vacuum Cleaner
Wipe and clean the vacuum cleaner with a
soft and dry cloth. Before cleaning, remove
the vacuum cleaner from the charging dock
and switch it off.
Cleaning the Dirty Tank and
D1
Filter
Replacement
Frequency
N/A
N/A
N/A
N/A
N/A
N/A
Publicidad
