Auerswald COMmander 6000 Manual De Instrucciones página 43

Extension Options on the Basic Unit
Important: If a non-compatible COMmander 4S
operated in a COMmander 6000/R/RX, repair charges are required. Use these modules
only labelled as version Rev. 2 or Rev. 3.
Note: The connection units (RJ-45 socket or spring clamp connection) depend on the
version (with R or without). Only one of the following connection units may be available.
Modules for retrofitting with an external analogue port are not available for this PBX.
Connection Options on the COMmander 8/16VoIP (R) Module
COMmander 6000/R/RX - Instructions V11 11/2018
6000R: 5 variable slots (slot A - E)
6000RX: 15 variable slots (slot A - E, F - O)
for the modules:
• COMmander 8VoIP R module
• COMmander 16VoIP R module
• COMmander VMF R module
• COMmander S
2M
• COMmander 4S
0
• COMmander 8S
0
• COMmander 8U
P0
• COMmander 8a/b R module
• COMmander 2TSM R module
6000R: extension to the 6000RX by a module
• COMmander 6000R Xtension
module is damaged when being
0
2 Ethernet ports, of which one is for connection to the
basic unit, connection via RJ-45 socket,
8/16 VoIP channels for internal IP and Internet telephony
(SIP-compliant in accordance with RFC 3261; support for
SIPS, SRTP, T.38 and VoIP-Codecs G.711 μ-Law/a-Law,
G.723.1, G.726, G.729A/E and iLBC)
Important: Due to technical reasons, when inserting the
first COMmander VoIP (R) module, the VoIP channels on
the basic unit must be switched off.
Important Information
R module
R module
R module
R module
43