Commissioning (Commander 6000R/Rx); Updating Or Upgrading The Pbx - Auerswald COMmander 6000 Manual De Instrucciones

Commissioning (COMmander 6000R/RX)

• Close the casing before you put the PBX into operation.
Requirements:
• PBX connected to earthing and casing closed
Connect the PBX to a freely accessible Schuko socket.
The Power (on the lower edge of the casing) and Status (on the main
circuit board) LEDs light up several seconds/minutes in red and
orange. When the LEDs light up in green, the PBX is ready for
operation.
Note: If the Power LED remains continuously lit in red, an error has occurred. Please
contact your dealer or the manufacturer directly.
Commissioning (COMmander 6000R/RX)

Updating or Upgrading the PBX

Warning: Touching voltage-carrying conductors or phone connections can cause
life-threatening electric shocks. The PBX contains hazardous voltages, even outside
of the power supply unit (for instance ringer voltages). Work on active, contact-
hazardous parts is only permitted after creating a voltage-free state. Working close to
active parts is only permitted if these parts are voltage-free or are protected against direct
contact .
• The Power button switches off the power on the module expansion slots and on the base
circuit board. If the system is switched off, a qualified electrician can replace or install
expansion modules. When installing or replacing a module, only touch the fixing
components of the front plate where necessary. Do not insert any electrically conductive
objects into the casing, since hazardous voltages are still present in the power supply
unit of the system.
Caution: Electrostatic charges can destroy sensitive components.
•Discharge electrostatic charges from yourself before touching the circuit boards
with your hands or any tools. To do this, touch a preferably earthed metal object, such
as the PBX's earthing terminal or a computer case.
Important: Before you insert a module, first make the necessary port settings on the
module (operating modes and terminators).
Requirements:
• Screw driver (Phillips)
1. Remove the blind panel or the old module:
• Blind panel: Loosen the screws and remove the blind panel.
58
COMmander 6000/R/RX - Instructions V11 11/2018