Internet And Voip Terminals As Well As Pc And Printer At The Ethernet Port - Auerswald COMmander 6000 Manual De Instrucciones

Installation
Requirements:
• Enabled operating mode "S
• Terminators enabled at both ends of the connection – in the NTBA and in the PBX on the
external S port in question
0
operating mode "S external"
0
If the connections have a slight distance, a
direct connection via the RJ45 socket can be
made (cable in the scope of delivery).
If the connections have a greater distance,
then a cable must be laid fixed on the
terminal clamps of the external S

Internet and VoIP Terminals as well as PC and Printer at the Ethernet Port

Connection possibilities:
• PC
• Internet (VoIP accounts with one or more VoIP phone numbers similar to the PMTP
connection on ISDN and VoIP accounts with an extensions block similar to the PBX
connection under ISDN, based on the SIP-DDI feature (also known as SIP trunking))
• COMfortel 1400 IP/2600 IP/3600 IP system phones
• COMfortel 3200/3500 system phones
• COMfortel VoIP 2500 AB system phones
• COMfortel DECT IP1040 Bases for COMfortel DECT 900C and some GAP capable DECT
handsets from other manufacturers (you find further information on the internet)
• IP DECT single- and multicell servers COMfortel WS-400 IP and COMfortel WS-650 IP for
COMfortel M-100, COMfortel M-200/210 and COMfortel M-300/310 DECT handsets.
• Standard VoIP phone (SIP), e. g. COMfortel 1200 IP
• Softphones (SIP)
• IP switch relays (e.g. NETIO 230B, WebRelay (identical to Keil), Energenie EG-PM2-Lan,
Philips hue)
• IP door terminals (e.g. Telecom Behnke Serie 20 IP, Baudisch SIP door terminal Maxi,
TCS FBI 6101, ELCOM LBM-300)
Requirements:
• For Internet access: Broadband Internet connection (e. g. DSL router, TV cable router)
• Existing network (LAN) or single switch (for VoIP terminals) with a data transmission rate
of 100 Mbit/s
66
external" on the S
0 0
port.
0
COMmander 6000/R/RX - Instructions V11 11/2018
port in question
terminators enabled
NTBA
external S port
0