Turning On Or Off The Bluetooth Function; Setting The Bluetooth Standby Mode; Other Functions; Enabling The Secure Link Function - Sony HT-CT180 Manual De Instrucciones

Ocultar thumbs Ver también para HT-CT180:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

F:\HT-CZ1-11_UC2\4559026111\4559026111HTCT180UC2\01GB-
HTCT180UC2\060OTH.fm
010COV.book Page 11 Tuesday, December 2, 2014 2:44 PM
Turning on or off the
BLUETOOTH function
Hold down SURROUND for 5 seconds,
then CLEARAUDIO+ for 5 seconds.
On: The ANALOG indicator flashes
twice.
Off: The OPTICAL indicator flashes
twice.
Note
• If you change the setting to off, the
BLUETOOTH function is disabled.
Setting the BLUETOOTH
standby mode
When the system has pairing
information, the system is in
BLUETOOTH standby mode even when
it is turned off.
Hold STANDBY down for 5 seconds.
On: The ANALOG indicator flashes
twice.
Off: The OPTICAL indicator flashes
twice.
Note
• During BLUETOOTH standby mode,
standby power consumption increases.

Other Functions

Enabling the Secure Link
function
You can specify the wireless connection
to link the Bar Speaker to the subwoofer
using the Secure Link function. This
function can help prevent interference if
you use multiple wireless products or
your neighbors use wireless products.
1
Press LINK on the rear of the
subwoofer.
You will hear beeps from the
subwoofer.
2
Hold down PAIRING on the Bar
Speaker for 5 seconds, then VOL –
for 5 seconds.
The OPTICAL and ANALOG
indicators flash alternately.
When the Bar Speaker is linked to
the subwoofer, the indicators stop
flashing.
If it failed, the indicators light up for
5 seconds. Try again the above
operation.

Auto standby function

The system enters standby mode
automatically when you do not operate
the system for about 20 minutes and
the system is not receiving an input
signal.
4-559-026-11(1)
masterpage:
Right
11
GB
HT-CT180

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido