REMOVING THE FREEZER ACCESSORIES
1. Tilting
Pocket
To remove - Pull both brackets( 1 ) upward
until you hear a clicking
sound and remove the pocket
To replace - Hook the ends of the pocket
into both brackets
( 1 )
and push down until it locks into place.
2. ICE BUCKET
To remove
- Lift the ice bucket( 1 ).
To relocate - Place the ice bucket
into the Super extended
drawer(
2).
3. Auto Pull Out Drawer
To remove
- Pull the drawer out to full extension.
Tilt up the rear of the drawer and lift straight out.
To relocate - Place the drawer onto the rails( 4 ) by tilting it up.
Lower the drawer into place until it is horizontal and
slide the Drawer( 3 ) in.
\
4. Freezer Drawer
Bin
To remove the drawer - Pull the drawer out fully. Tilt up the
rear of the bin and lift it out to remove.
To relocate the drawer - Place the bin into the rail assembly.
To remove the divider
- Pull the divider straight up.
To relocate the divider - Hook the top corners of divider( 1 )
over the hole of the bin( 2 ).
//_
Do not allow a baby or children to go inside the drawer bin.
CAUT_IN They could damage the Refrigerator and seriously injure
themselves. Do not sit on the Freezer door. The door may
break. Do not allow children to climb into the Freezer basket.
//_
If you remove the divider to clean the basket bin, you must
WAR_NI G reinstall the divider using 2 screws after cleaning to prevent
children from getting trapped inside the basket.