Descargar Imprimir esta página

GE WNRD2050D1WC Manual Del Propietário página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

PERFORMANCE (cont.)
Snags, holes, tears, rips
or excessive wear
Wrinkling
OPERATION
Washer pauses
during wash cycle
Washer pauses during
spin cycle
Washer won't operate
Possible Causes
Pins, snaps, hooks, sharp
buttons, belt buckles,
zippers and sharp objects
left in pockets
Undiluted chlorine bleach
Chemicals like hair bleach
or dye, permanent wave
solution
Improper sorting
Overloading or
incorrect water level
Incorrect wash and
dry cycles
Repeated washing in
water that is too hot
Possible Causes
The DELICATES cycle was chosen • This is normal. The DELICATES cycle has a short soak
This is normal
Washer is unplugged
Water supply is turned off
Controls are not set properly
Lid is open
Circuit breaker/fuse is
tripped/blown
Electronics need to be reset
START was not pressed
Extremely low water pressure
Lid magnet missing
What To Do
• Fasten snaps, hooks, buttons and zippers.
• Remove loose items like pins, objects in pockets
and sharp buttons.
• Turn knits (which snag easily) inside out.
• Check bleach package instructions for proper amount.
• Never add undiluted bleach to wash or allow clothes
to come in contact with undiluted bleach.
• Rinse items that may have chemicals on them before
washing.
• Avoid mixing heavy items (like work clothes) with
light items (like blouses).
• Try a fabric softener.
• Load your washer so clothes have enough room to move
freely with water covering all of the clothes.
• Match Cycle selection to the type of fabric you are
washing (especially for easy care loads).
• Wash in warm or cold water.
What To Do
period.
• The washer may pause during the spin cycle to remove
soapy water more efficiently.
• Make sure cord is plugged securely into a working outlet.
• Turn both hot and cold faucets fully on.
• Check controls.
• Close lid.
• Check house circuit breakers/fuses. Replace fuses or
reset breaker. Washer should have separate outlet.
• Unplug washer, wait 2 minutes, plug back in
and press START.
• Press START.
• Press START again.
• Call for service.
9

Publicidad

loading

Este manual también es adecuado para:

Wnrd2050