Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
8. The (orange) RJ45 LED will illuminate on both the local
transmitter unit and remote receiver unit to indicate a signal
is received from source to display. The screen should now
display on the connected monitor.
USB/IR/Toslink Controls
The extender kit provides the following functional controls:
• USB 1.1 – One Micro-USB input at transmitter, dual USB-A
outputs at receiver
• Bi-Directional IR – Dual 3.5 mm jacks at both the
transmitter and receiver
• Toslink – Audio output at receiver
Note: All of the following USB/IR/Toslink steps are optional. For port
locations, refer to the diagram in the Extender Kit Installation section.
IR Control
1. Connect a user-supplied IR-OUT cable to the transmitter
unit's IR-OUT port. Place the sensor on the IR-OUT cable in
an unobstructed area within clear view of the device being
controlled. Then connect a user-supplied IR-IN cable to the
receiver unit's IR-IN port. The IR-IN cable will communicate
the desired command via the transmitter's IR-OUT cable.
Note: The IR-OUT cable receives the signal from the remote control and
sends it to the device being controlled (e.g. Blu-ray™ player, etc.).
8
Publicidad
