Eaton TRIPP LITE B127A-1A1-BCBH Manual Del Propietário página 7

Installation
1. Using a USB 3.0 Type-C cable, connect the USB Type-C source
to the INPUT port on the local transmitter unit.
2. Optional: Using an HDMI 2.0 cable (such as P569-XXX-CERT
or P568-XXX-2A Series cables), connect a local monitor to the
LOCALOUT port on the B127A-1A1-BCBH local transmitter
unit.
3. Using Cat6 cable, connect the RJ45 port on the local
transmitter unit to the RJ45 port on the remote receiver unit.
4. Using an HDMI 2.0 cable (such as P569-XXX-CERT or
P568-XXX-2A Series cables), connect the remote receiver
unit's HDMI port to a monitor.
5. Turn the power on to your connected TVs/monitors. The
LOCAL (orange) LED will illuminate to indicate the local port is
connected to a display.
6. Connect the external power supply to the local transmitter
unit and plug it into an available wall outlet or (optional)
a Surge Protector, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS). The POWER (green)
LED on the local transmitter unit will illuminate to indicate
the unit is receiving power from the external power supply.
The POWER (green) LED on the remote receiver unit will
illuminate to indicate the unit is receiving power from the
local transmitter unit through PoC technology.
7. Turn on the power to the USB Type-C source. The OUTPUT
(orange) LED on the local transmitter unit will illuminate to
indicate a signal is received from the source.
7