VEVOR FF-Q901 Manual Del Usuario página 10

1.Pay particular attention to the ABRASIVE HOSE (#21), the DEADMAN
VALVE (#25), and the NOZZLE (#27) as they will wear out much more
quickly than the other pieces.
2. The ABRASIVE HOSE needs replacing when its sidewalls develop leaks
or show blisters in the surface. Do not use if any of these problems are
present.
INSTALLATION NOTES
1. Please dispose of all plastic bags carefully and keep them away from
children and pets.
2. Check all components provided according to the list in this
manual.Make sure you have all of the parts listed.
3. Although paying particular attention when manufacturing this product,
you must be careful during the assembly process to avoid being scratched
by sharp edges.
4. Wear eye-protective goggles and protective gloves during assembly and
use.
5. The product should be placed on a flat surface.
ASSEMBLY INSTRUCTIONS
1. Refer to the drawing for step 1, assembling the intake manifold(12),
First, attach the pressure gauge(9), to the top of the intake manifold,
turning the gauge so that is can be see across the top of the tank. Next,
attach the throttling valve (31) to the bottom of the manifold. Attach the
nipple connector, to the throttling valve. Attach the joint pipe(10), to the
manifold.
2. Refer to the drawing for step 2, to assemble the water trap filter (9)
nipple connector (11) is screwed into each side of the filter. On one side,
attach the air supply valve (31), to the nipple connector (10), and then
attach the male/female connector(8), to the other side of the air supply
valve. When you're ready to operate the abrasive blaster, the air hose from
the compressor will fasten to the male/female connector(8).
9