Publicidad
Idiomas disponibles
Idiomas disponibles
blasting.
5. Use thick gloves with to protect your hands.
5. Use backboards to prevent over spray from hitting someone or
something else because the dust will travel a long distance. Blast in a large
open area to minimize abrasive accumulation in surrounding areas.
7. Do not pull media tank around by the abrasive hose or let tank fall over
as a fitting may break rendering the machine unsafe.Media and air under
125 PSI have a very high destructive force.Never leave a pressurized
machine unattended. If an emergency occurs,such as a burst blast
hose,shutdown the machine immediately.
8. Drain air out of tank through the inlet valve and disconnect power before
maintenance cleaning of any kind.When removing nozzle,caution must be
exercised as air pressure may still be in the hose if the nozzle is plugged.
9. For safe operation,perform recommended preventive maintenance on
blaster tank, remote unit and accessories.Replace all worn parts before
they fail. Immediate replacement of worn components is required.Failure to
replace worn components could result in exposing the operator or
bystanders to high speed media and compressed air, causing serious
injury.
10. Do not use corrosive materials of any type in unit. Use only clean, dry
media.
11. Do not splice abrasive hose.The splice will wear out quickly and may
violently spray media over the surrounding area. A worn blast hose could
suddenly fail by bursting, Couplings and nozzle holders may not
adequately
grip
worn
hose,causing
them
to
blow
off
under
pressure.Compressed air and abrasive escaping from a burst hose, or
disconnected coupling or nozzle holder,could cause severe injury.
12. Welding, grinding, or drilling on the blast machine could weaken the
vessel. Compressed air pressure could cause a weakened blast machine
to rupture, resulting in death or serious injury. Welding, grinding,or drilling
on the blast machine vessel,without a National Board R stamp voids the
ASME and National board certification if applicable.
13. Always place the machine so that the outlet is pointed away from any
objects or persons. Stand clear of the path of exiting abrasive. It may come
12
Publicidad
