Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM/CAUSE
Surging of blast flow:
Air pressure too low
Too much media
Excessive media consumption:
Media valve open too far
Air pressure too low
Clogging and plugging of blast flow:
Debris in media
Media size too large
Nozzle plugs
Nozzle plugs
Wet media
Moisture in abrasive media:
Wet media
Water in air
Water in tank
Humid weather:
Moderate humidity
Moderate humidity
High humidity
Overtaxed compressor:
Compressor too small
Nozzle size too large
TROUBLE SHOOTING TIPS
18
POSSIBLE SOLUTION
See "Lack of Air Pressure"
Adjust media valve
Close slightly
Check pressure gauge
Purge and screen
Use smaller grit size
Use larger nozzle
Adjust media valve
Dry media,drain water from air
Change or use dry media
Drain water from airlines
Empty,dry out and refill
Keep media as dry as possible
Use
drier
separator
Avoid that period of use if
possible
Restrict time used
Use smaller size
or
moisture
Publicidad
