Publicidad
Idiomas disponibles
Idiomas disponibles
3. Place the tank (15) on a table with the four clips up. Refer to the drawing
for step 3. Screw the water trap filter (9) and its parts into the hole at the
side of the intake manifold. Then screw the open end of the joint pipe (10)
with intake manifold (12) and pressure gauge (9) attached into the
threaded hole on the side of the filler pipe on Top of the tank. Again, be
sure that the manifold and gauge are vertical.
4. Refer to the drawing for step 4, assembly of the abrasive outlet valve
into the hole at the bottom of the tank; Attach four parts, in order:Nipple
connector(11); abrasive metering valve(30); nipple Connector(11) and the
abrasive outlet pipe(12).
5. Refer to the drawing for step 5,assembly of the nozzle DEADMAN valve
(25). In this assembly process, you| ll select one of the four nozzles (27).
This is not a permanent selection, as you may change nozzles according to
the job being done. Screw the adapter (23), into the nozzle DEADMAN
valve (25). Screw the gasket (26) into the nipple connector, then add a
nozzle (27) and the nozzle cap-nut (28).
6. Refer to the drawing for step 6, for connecting the abrasive metering
valve assembly and the assembly.
Slide the two hose clamps (22), over each end of the abrasive hose(21)
press one end of the hose, over the nipple on the abrasive outlet pipe(12)
and the other end over the adapter (23). Both hose ends should be firmly
seated on the nipples. Slide the hose clamps along the hose to each nipple
and tighten the clamps very firmly.
7. Fasten the two handlebars (06) to the tank using four pan screws (02)
and four washers and four hex nuts. Note: keep the handle curve ends
upward.
8. Locate the axle(29), and slide it through the holes in the sides of the
handlebars (06). Place one wheel(16) at each end of the axle and fast en
then into place with cotter pins(14) and washer (34)
9. Insert the fixed foot (17) onto the fitting on the bottom of the tank near
the edge. Use your last cotter pin (14) to hold the foot to the tank.
10. Before beginning operations, go back over each connection, double
checking to ensure that all are tight and properly seated.
10
Publicidad
