ACD GRUPPE MFT10 Guía Breve página 11

2.5 Spout Set for interface cable
The grommet set consists of the following feedthrough grommets and the corresponding dummy plugs. They
are already included with delivery of the MFT10/MFT12.

1x 3 mm

1x 4 mm

1x 5 mm

1x 6 mm

1x 7 mm

1x 8 mm
Figure 16: Spout Set for Interface Cable
2.5.1 Security Advices
Unintended use of the spout set should be avoided.
ATTENTION
2.5.2 Mounting
To insert or remove the grommet, the cable shaft cover with screw connection must be removed from the
back of the device. To do this remove the eight M4 screws.
Grommets that match the cable cross-section must be used to ensure

IP protection to IP65. Feedthroughs that are not used must be closed
off with a feedthrough grommet and a dummy plug that matches the
NOTE
cross-section.
MFT10_MFT12_Accessories_Accesorios_Brief_Overview_Resumen_breve_FCC_V1.10_en_es 11 / 28