Publicidad
Idiomas disponibles
Idiomas disponibles
5. SETTINGS
4 settings that can be changed using a flathead 3 mm screwdriver:
min
Delay when output contact H1-H2 (ventilation control) drops off.
5
30
Adjustable from 10s to 120min.
In the case of an AJUST'AIR OPTIC application, do not modify the factory setting
10s
120
= sur 15min.
Time off
min
Delay on switching on of output contact H1-H2 (ventilation control).
1
5
Adjustable from 0s to 10min.
In the case of an AJUST'AIR OPTIC application, keep the factory setting = 0s.
0s
10
Time on
Sensitivity threshold to ambient light; influence on output L↓ (lighting control).
Adjustable from 5 to 1000lux.
300
500 1000
5
Factory setting = maximum "ON" value, i.e. the sensor will activate its lighting output
even in broad daylight in the event of presence detection.
test
on
adjust as needed.
Lux
min
Delay on switching off of output L↓ (lighting control).
10 30
Adjustable from 15s to 30min.
1
Factory setting = 15min.
adjust as needed.
15s
Time
6. MAINTENANCE
Before starting any maintenance operations, don't forget to unplug the device
from the mains.
This product requires regular cleaning (at least once a year) to avoid dust build-
up around the lens taking care not to scratch it.
Clean the body of the device with a wet cloth. Do not use detergents or other
abrasive products that could damage the finish / colour of the plastic.
Do not immerse the device or spray water onto it.
7. PUTTING OUT OF SERVICE AND RECYCLING
EEC legislation and our consideration of future generations mean that
we should always recycle materials where possible; please do not for-
get to deposit all packaging in the appropriate recycling bins. If your
device is also labeled with this symbol, please take it to the nearest
Waste Management Plant at the end of its servicable life.
EN
17
Publicidad
